Use Matte Top Coat as a base and let dry. Apply sticky polish over selected design on the stamping plate.
Hold scraper card at a 45-degree angle and gently scrape excess polish off the design to the edge of the plate.
Quickly use the soft stamper head to pick up the image with an up/down motion. The design should now be on the stamper head.
With a rolling motion, apply the design from the stamper to your nail and gently press chrome powder to stamped design on nail. Dust off excess powder.
Seal in your artwork with No Smudge Polish Top Coat or UV/LED Gel Top Coat.
18 Free Polishes will only dry with natural heat from fingers or a hot blow dryer on low. 2-3 coats of top coat is recommended. Allow to dry between layers.
Remove the blue protective film from new stamping plates before use. Clean polish from plates with an acetone wipe.
Clean stamper head with tape or a lint roller. Do not use acetone or alcohol on stamper heads.
choosing a selection results in a full page refresh
